The sandblasting machine relies on compressed air to generate high-pressure ejection of abrasives. Sandblasting abrasives are relatively large consumables in sandblasting machines. Therefore, many users often ask how many kilograms of abrasives the machine consumes in one hour when purchasing a sandblasting machine. Just like energy, excessive consumption is waste and will increase costs. Therefore, when users choose to buy sandblasting machines, saving abrasives is a priority for purchasing machines. Now list The main factors of abrasive consumption are dust collector, separator, air pressure, sandblasting tube and abrasive recovery system.

For a better dust collector, the dust in the dust collector bucket should be cleaned regularly, and the dust in the filter cartridge should be cleaned to achieve better separation. If the separation effect of the dust collector is not good, the powder layer will be mixed with the sand material for the second time. use. The second separator, the general separator is divided into air separation method and mechanical separation method. Now most sand blasting machines use air separation method for separation. Before purchasing the machine, the user must provide the workpiece you are processing and the required material Sand material, so that engineers and technicians can design corresponding separators for better separation.

The third air pressure, the air pressure should be adjusted properly. You can adjust the appropriate pressure according to the hardness and material of the workpiece you are processing. If the pressure is too high, it will increase the speed of abrasive grinding. If the pressure is too high, the sand ejection rate will be high. The material will wear once on the workpiece, and then bounce and impact wear in the cabin. The second sand blasting tube, the excessive bending of the sand tube will produce certain resistance to the abrasive, which will increase the impact of the abrasive on the sand tube, one will reduce the service life of the sand tube, and the other will cause friction between the abrasive and the abrasive. So don't underestimate these details. The fourth sandblasting tube, excessive bending of the sand tube will produce a certain resistance to the abrasive, which will increase the impact of the abrasive on the sand tube, which will reduce the service life of the sand tube and cause friction between abrasives. So don't underestimate these details. For the fifth spray gun, if the spray gun is worn or damaged, excessive abrasive waste will be generated, and the processing efficiency will be reduced. First, check whether there will be air leakage at the gas nozzle, whether the diameter of the sand nozzle is too large or deformed, and whether the gun body is damaged. damaged. The sixth is the sand recovery system. Currently, the recovery systems used include pneumatic recovery and mechanical recovery, depending on the sand material. If the sand material is non-metallic, it is better to use the pneumatic recovery system. If it is metal sand material, mechanical recovery is optional. Recovery and pneumatic recovery are used simultaneously. The specific general reasons are the above points, so many details can promote the level of your cost.